About this role

Read blueprints, drawings and specifications to determine work requirements
Apply successive coats of compound and sand seams and joints
Apply, level and smooth coats of plaster
Clean and prepare surfaces
Cure freshly plastered surfaces
Cut and install metal corner beads to protect exterior corners
Fill joints, nail indentations, holes and cracks with joint compound using trowel and broad knife
Finish corners and angles and create decorative designs in finish coat, if required
Measure, cut, fit and install drywall sheets
Mix plaster ingredients to desired consistency
Mould and install ornamental plaster panels, cornices and trim
Position and secure sheets to metal or wooden studs or joists
Smooth out excess compound and allow coat to dry
Spray acoustic or texture materials over walls and ceilings
Tape over joints using taping machine and embed tape in compound
Trowel or spray coats of stucco over exteriors of buildings to form weatherproof surfaces
Cut openings in lath for heating and ventilation piping, ducts and electrical outlets
Install corner beads and wire mesh around beams to which plaster is to be applied
Install exterior and interior steel studs
Install metal stud framing and furring for interior drywall or plaster walls and ceilings, using hand and power tools
Install vapour barriers and thermal and sound insulation
Prepare wall and ceiling layouts
Work at heights, on scaffolding or swing stages

By mail: 536 38A Ave SE Calgary, Alberta T2G1X4

Requirements

Education Secondary (high) school graduation certificate

Experience 7 months to less than 1 year

$28.00 hourly